DJ levels: gain, faders, meters and staying out of the red
Lessons · Part 2 · Core skills · Lesson 6 of 21 · 4 min
Gain, faders, meters and the master. Why great DJs never touch the red.
This is the written version of “Levels: loud, clean and even”. The lesson itself runs on two turntables and a mixer in your browser, with practice songs built in, and one step is demonstrated on the decks before you try. It is free, with nothing to install. Do this lesson on the decks.
The lesson, step by step
Switch to Pro
This lesson uses controls that the Simple layout hides. Switch the layout to Pro at the top of the page. You can switch back any time.
Get a record spinning
Load a song on deck A and press play. The practice songs are fine.
Read the meter
The bar beside each fader shows that deck’s level. Green is healthy. Amber is the top of the safe zone and where your loudest drum hits should land. The small light above it flashes red when the signal clips, which sounds harsh and tires ears quickly.
Gain sets the level, the fader plays it
Songs are mastered at different loudness. GAIN, at the top of each column, makes them equal before they reach the fader. Backspin sets a starting gain for every song automatically. Turn deck A’s GAIN up and watch the meter climb, then double-click it to reset.
Match the next song before anyone hears it
Before a blend, compare the two meters and nudge the incoming song’s GAIN until they peak at the same height. A transition where the new song arrives quieter loses the room. One that arrives louder makes people wince.
Two songs add up
When both decks play at once their levels stack, which is another reason to cut the bass on one of them. If the master meter at the top right starts flashing red during a blend, pull both faders down a touch.
The sound engineer’s rule
Leave the master alone and never mix into the red. If the room needs more volume, that is the amplifier’s job. DJs who run hot get distortion on the night and are not asked back.