How to use EQ and filter when DJing
Lessons · Part 2 · Core skills · Lesson 5 of 21 · 4 min
Use bass, mid, high and the filter to make two songs sound like one.
This is the written version of “EQ and filter: carving space”. The lesson itself runs on two turntables and a mixer in your browser, with practice songs built in, and 3 steps are demonstrated on the decks before you try. It is free, with nothing to install. Do this lesson on the decks.
The lesson, step by step
Two songs, one speaker
When two songs play together their sounds pile up. The EQ knobs let you decide which song owns the bass, the middle and the top. Let’s get both practice songs playing together.
Bring a song in with no bass
The golden rule: one bassline at a time. Turn deck B’s BASS all the way down. Now B adds rhythm and texture without fighting A’s low end.
Swap the bass
On a phrase edge, turn A’s BASS down and B’s BASS back to the middle, as close to together as you can. The energy hands over from one song to the other. This is the classic transition.
Sweep the filter
The FILTER knob is two tools in one. Turn deck A’s FILTER slowly to the right: the bass and body thin out until only fizz is left. It is the smoothest way to make a song leave.
Reset
Double-click any knob to snap it back to neutral. Reset deck A’s BASS and FILTER.
What good DJs do with EQ
Cut, don’t boost: turning things up eats your headroom. Take a little HIGH off the incoming song so two sets of hi-hats don’t hiss. Never mix into the red: if the clip light above a meter flashes, turn the song down, not the master up. Quiet and clean beats loud and crunchy every time.