BackspinDo this lesson

Scratching with the crossfader: cuts and slip mode

Turn the baby scratch into real patterns with the crossfader, the cut curve and slip mode.

The lesson, step by step

  1. Switch to Pro

    This lesson uses controls that the Simple layout hides. Switch the layout to Pro at the top of the page. You can switch back any time.

  2. Get a record spinning

    Load a song on deck A and press play. The practice songs are fine.

  3. Set the crossfader to cut

    Under the crossfader, switch BLEND CURVE to CUT CURVE. Now the sound snaps fully on the moment the fader leaves the edge, instead of fading in. Scratch DJs always play this way.

  4. Turn on slip

    Press SLIP on deck A. While you hold the record, the song keeps running silently underneath, and when you let go it carries on from where it would have been. You can scratch for as long as you like and never lose your place.

  5. The forward scratch

    Play only the forward push and hide the pull back. Push the record forward with the crossfader open, close the fader, pull back in silence, open, push. Hold F for the push, D for the pull, and use ← → for the fader.

  6. The chirp

    Close the fader exactly as the push ends and open it as the pull begins, so each stroke is clipped short. The sound turns into a bird-like chirp. It is the first two-handed scratch most people learn, and it takes a while. That is normal.

  7. The transformer

    Move the record slowly in one long stroke and tap the fader open and closed in rhythm. One stroke becomes a stutter of notes. Tap in triplets against a straight beat for the classic sound.

  8. Find something worth scratching

    Sharp, short sounds cut best: a snare, a vocal shout, a horn stab. Save a hot cue right at the start of one, and you can snap back to it between phrases. Real scratch DJs own whole records of nothing but these.

  9. Put the mixer back

    Switch the crossfader back to BLEND CURVE for mixing, or your next blend will slam in.

Do this lesson on the decks