BackspinDo this lesson

How to prepare songs for a DJ set

Check grids, fix wrong tempos, set cue points. The unglamorous hour that makes the night easy.

The lesson, step by step

  1. Switch to Pro

    This lesson uses controls that the Simple layout hides. Switch the layout to Pro at the top of the page. You can switch back any time.

  2. Get a record spinning

    Load a song on deck A and press play. The practice songs are fine.

  3. Check the beat grid

    Look at the scrolling waveform. The thin lines should sit exactly on the kick drums, with a brighter line on the first beat of each bar. Sync, loops and Auto Mix all trust this grid, so a wrong grid means a wrong everything.

  4. Wrong tempo? Half or double it

    Drum and bass at 174 is often read as 87, and slow hip-hop the other way round. GRID ÷2 and ×2 fix that in one press. Try ×2 and then ÷2 to put it back.

  5. Bar line on the wrong beat?

    If the bright bar line sits on beat 2 instead of beat 1, the ◂ and ▸ buttons slide it a beat at a time. The − and + buttons beside them nudge the whole grid by a few milliseconds when the lines sit just beside the kicks.

  6. No grid at all? Tap it

    For songs with no clear drums, tap the TAP button along with the beat four times or more. Backspin sets the tempo from your taps and treats your last tap as a "1".

  7. Set your cue points

    A sensible habit: hot cue 1 on the first beat, 2 where you would start mixing in, 3 on the drop, 4 on the breakdown. Same numbers on every song, so your fingers know where to go without looking. Cues and grid fixes are saved with the song.

  8. Know your music

    Listen to every song all the way through before you play it out. Know where the vocal comes in, how long the outro is, whether it has a false ending. Software can tell you the tempo. Only you can know the song.

Do this lesson on the decks